SATO S84NX - Page 199

199
[Enable]
Enable or disable the functions for NTP.
The options are as follows:
Enabled
Enable the NTP function.
Disabled
Disable the NTP function.
[Error]
Set to show the NTP error message if detected.
The options are as follows:
Enabled
Shows the error message.
Disabled
Does not show the error message.
[Time Server IP]
Set the IP address of the NTP server.
The setting range is as follows:
0.0.0.0 to 255.255.255.255
The IP address should normally be set to 0.0.0.0 (the default value). For the default value, the global
NTP servers are assigned automatically. Set to a valid IP if the time synchronization is requested for a
specific server.
[LPD]
Set the functions for LPD.
The setting items are as follows:
[Enable]
Enable or disable the LPD function.
The options are as follows:
Enabled
Enable the LPD function.
Disabled
Disable the LPD function.
[DNS Lookup]
Enable or disable the DNS Lookup function.