205
[Destinations]
Set the number of trap destinations.
The setting range is from 1 to 3.
[Destination 1]
Set address 1 for the trap destination.
The displayed IP version differs depending on the [IP Version] setting.
[Destination 2]
Set address 2 for the trap destination.
The displayed IP version differs depending on the [IP Version] setting.
Appears only if you have selected [2] or [3] in the [Destinations] menu.
[Destination 3]
Set address 3 for the trap destination.
The displayed IP version differs depending on the [IP Version] setting.
Appears only if you have selected [3] in the [Destinations] menu.
[Community]
Set the Traps community name.
Appears only if you have selected [1] or [2c] in the [SNMP Version] menu.
You can enter 1 to 32 characters. Alphabets, numbers and symbols can be used.
Initial setting: trapcom
[User]
Set the Traps user name.
Appears only if you have selected [3] in the [SNMP Version] menu.
You can enter 1 to 32 characters. Alphabets, numbers and symbols can be used.
Initial setting: trapuser
[Engine ID]
Set the engine ID.
Appears only if you have selected [3] in the [SNMP Version] menu.
Initial setting: Created from the MAC address.
Hexadecimal characters are allowed and the range is from 10 to 64 characters. (Only an even number
of characters is allowed.)
[Security]
Set the security level.
Appears only if you have selected [3] in the [SNMP Version] menu.
The options are as follows:
• [None]
To Next Page
Loading...