SATO S84NX - Page 220

[RS-232C]
220
• When [Tools] > [Barcode Checker] > [Test] > [Interface] is set to [RS-232C Reader],
the following message appears on the screen and you cannot change the [RS-232C]
menus.
"Reader is set for RS232C connection destination. Please check the setting of barcode
checker."
The setting items are as follows:
[Baudrate]
Set the baudrate (bps).
Available to change only if you have selected [RS-232C] in the [Tools] > [Barcode Checker] > [Test] >
[Interface] menu.
The options are as follows:
• [2400]
• [4800]
• [9600]
• [19200]
• [38400]
• [57600]
• [115200]
[Parameters]
Set the data parameters.
Available to change only if you have selected [RS-232C] in the [Tools] > [Barcode Checker] > [Test] >
[Interface] menu.
The options are as follows:
Refer to the table below for the parameter configurations.
• [8-N-1]
• [8-O-1]
• [8-E-1]
• [8-N-2]
• [8-O-2]
• [8-E-2]
• [7-N-1]
• [7-O-1]
• [7-E-1]
• [7-N-2]
• [7-O-2]
• [7-E-2]
Parameter Configurations List