SATO S84NX - Page 221

221
Parameters Data length
(bit)
Parity Stop bit
(bit)
8-N-1 8 NONE 1
8-O-1 8 ODD 1
8-E-1 8 EVEN 1
8-N-2 8 NONE 2
8-O-2 8 ODD 2
8-E-2 8 EVEN 2
7-N-1 7 NONE 1
7-O-1 7 ODD 1
7-E-1 7 EVEN 1
7-N-2 7 NONE 2
7-O-2 7 ODD 2
7-E-2 7 EVEN 2
[Flow Control]
Set the communication protocol.
Available to change only if you have selected [RS-232C] in the [Tools] > [Barcode Checker] > [Test] >
[Interface] menu.
The options are as follows:
• [READY/BUSY Multi]
• [XON/XOFF Multi]
• [STATUS3]
• [STATUS4]
• [STATUS5]
• [None]
[BCC]
Enable or disable the BCC check function.
Appears only if you have selected [RS-232C] in the [Tools] > [Barcode Checker] > [Test] > [Interface]
menu and if you have selected [STATUS5] in the [Flow Control] menu.
The options are as follows:
Enabled
Enable the BCC check function.