235
•
You can reset the counter pressing the button ([CLEAR]) when the counter is
1 or higher.
[Paper]
Set the paper type of RFID tags and the print reference position in the vertical direction.
The setting items are as follows:
[Types]
Set the paper type of RFID tags.
The options are as follows:
Label
Use normal RFID tags.
Side Hole Tag
Use side hole tags.
(1) Media feed direction
[Starting Point]
Set the print reference position of RFID tags in the vertical direction.
Set the print reference position as "+" for the direction of the paper feed and "-" for the direction
opposite to the paper feed.
The setting range is from -600 to +600 dots.
• When the direction of the paper feed is set to "+", the total length including other pitch
values should not exceed 25 mm (0.98"). If it exceeds 25 mm (0.98"), the product may
not stop properly.
• The length of 1 dot varies depending on the print resolution of the product.
◦ 203 dpi : 1 dot = 0.125 mm (0.0049")
◦ 305 dpi : 1 dot = 0.083 mm (0.0033")
◦ 609 dpi : 1 dot = 0.042 mm (0.0017")
To Next Page
Loading...