SATO S84NX - Page 253

253
[Prioritize]
Select the settings to be prioritized for each setting item of the SDPL command. You can set whether
to prioritize settings that are done through the product or through commands.
When you select [Settings] for an item, the setting specified in the [SDPL] menu of the product will be
used.
The setting items are as follows:
[Format Attribute]
Set whether to prioritize the settings that are done through the product or through commands for the
format attribute setting.
The options are as follows:
Commands
Prioritize the settings through commands.
Settings
Prioritize the settings that are done through the product.
[Pause Mode]
Set whether to prioritize the settings that are done through the product or through commands for the
pause mode setting.
The options are as follows:
Commands
Prioritize the settings through commands.
Settings
Prioritize the settings that are done through the product.
[1 Byte Codepage]
Set whether to prioritize the settings that are done through the product or through commands for the 1
byte code page setting.
The options are as follows:
Commands
Prioritize the settings through commands.
Settings
Prioritize the settings that are done through the product.
[SDPL Measure Unit]
Set whether to prioritize the settings that are done through the product or through commands for the
measurement unit setting.
The options are as follows: