SATO S84NX - Page 256

[SDPL]
256
[1 Byte Codepage]
Select the code page to be used for one-byte characters from the list.
You can change this setting if you have selected [Settings] in the [Prioritize] > [1 Byte Codepage]
menu.
[SDPL Measure Unit]
Set the measurement unit.
You can change this setting if you have selected [Settings] in the [Prioritize] > [SDPL Measure Unit]
menu.
The options are as follows:
• [Inch]
• [Millimeter]
[Scalable Font Style]
Set the style of the scalable fonts.
You can change this setting if you have selected [Settings] in the [Prioritize] > [Scalable Font Style]
menu.
The setting items are as follows:
[Bold]
Set whether to use bold for the scalable fonts.
The options are as follows:
Enabled
Use bold.
Disabled
Do not use bold.
[Italic]
Set whether to use italics for the scalable fonts.
The options are as follows:
Enabled
Use italics.
Disabled
Do not use italics.
[Feedback Character]
Enable or disable the <STX>a command.
You can change this setting if you have selected [Settings] in the [Prioritize] > [Feedback Character]
menu.