SATO S84NX - Page 429

429
Initial ValueSetting Item
S84NX S86NX
Initialized
by User
Reset/
Factory
Reset
[SDPL Measure Unit] [Commands] Yes/Yes
[Scalable Font Style] [Commands] Yes/Yes
[Sensor Type] [Commands] Yes/Yes
[Feedback Character] [Commands] Yes/Yes
[SOH Commands] [Commands] Yes/Yes
[Module Selection] [Commands] Yes/Yes
[Darkness] - Yes/Yes
[Factory Offset] - Yes/Yes
[Speed] - Yes/Yes
[Format Attribute] [XOR] Yes/Yes
[Pause Mode] [Disabled] Yes/Yes
[1 Byte Codepage] [CP 850] Yes/Yes
[SDPL Measure Unit] [Inch] Yes/Yes
[Scalable Font Style]
[Bold] [Disabled] Yes/Yes
[Italic] [Disabled] Yes/Yes
[Feedback Character] [Enabled] Yes/Yes
[SOH Commands]
[All Commands] [Enabled] Yes/Yes
[SOH-B Command] [Enabled] Yes/Yes
[SOH-C Command] [Enabled] Yes/Yes
[Others] [Enabled] Yes/Yes
[Module Selection] A Yes/Yes
[AEP]
[Enable] [Disabled] No/Yes