SATO S84NX - Page 522

522
Error Message 1118 (Write/Read Values Are not Consistent) (S84NX
Only)
When there is an error with the product, the error message appears on the screen.
Check the cause and countermeasure, and then take appropriate action.
To clear the error:
Press the button (RETRY), and then execute the retry/release operation set in [Retry Mode],
or press the button (ABORT).
Retry Mode
To cancel an entire print job, open and close the top cover to switch the product to Offline mode, and
then press the button (CANCEL).
Cause and Countermeasure Reference
Cause
The written value and read value do not match.
Countermeasure
Confirm the inlay and check the product and antenna
settings.
RFID Settings (S84NX Only)
RFID (S84NX Only)
Contact your SATO technical support if the error cannot be resolved.
Contact Information for When You Are in Trouble
• You cannot use an RFID tag that has caused an RFID tag error. An error message is
printed on the RFID tag that caused the error.