SBC PCD2 Series - Page 132

Saia-Burgess Controls AG
Manual I/O-modules for PCD1 │ PCD2 series │ Document 27-600 – Release ENG09 │ 2019-05-01
5-123
I/O modules PCD1|PCD2
PCD2.H210
5
Block diagram
E 0
E 1
E 2
E 3
A 0
A 1
User PROM Oscillator
FPGA
(Field Programmable
Gate Array)
PCD Bus
Input filter and adaptation from 24V to 5V
Output amplifier 5 .to. 32 V
DC (Uext)
Input 1
Input 2
Input 3
PUL
DIR
A 2
A 3
Output 2
Output 3
Input 0
For further information, please refer to manual 26/760, “PCD2.H210 - motion con-
trol modules for stepper motors”
Watchdog: This module cannot be used on the base address 240 (or 496 for the
PCD2.M17x), because it would interact with the watchdog, and would cause a
malfunction.
For details, please refer to the section A4 “Hardware Watchdog”, which describes
the correct use of the watchdog in conjunction with PCD components.