SBC PCD2 Series - PCD3.B100, Combined with 2 Inputs + 4 Digital I;Os; Technical Data on Inputs; Technical Data on Outputs

Saia-Burgess Controls AG
Manual I/O-modules for PCD1 │ PCD2 series │ Document 27-600 – Release ENG09 │ 2019-05-01
6-55
I/O modules PCD3
PCD3.B100
6
6.7.1 PCD3.B100, combined with 2 inputs + 4 digital I/Os
Application
Economical combined input/output module with:
● 2 inputs 24 V / 8 ms for source operation, electrically connected
● 2 transistor outputs 0.5 A / 5…32 VDC, electrically connected, not short circuit
protected, and
● 4 combined inputs/outputs 24 V/8 ms or 0.5 A / 5…32 VDC on common I/O
terminals.
Technical data on inputs
Number of inputs: 6 (2 + 4), electrically connected,
source operation
Input voltage: 24 VDC smoothed or pulsed
2 inputs E0 and E1
low-range:
high range:
-30…+5 V
+15…+32 V
4 inputs E/A2…E/A5
low-range:
high range:
-0.5…+5V*)
+15…+32 V
All 6 inputs:
low-high switching threshold:
high-low switching threshold:
Hysteresis:
input current (24 VDC):
switching delay 0-1 (24 VDC):
switching delay 1-0 (24 VDC):
13 V typically
6 V typically
7 V typically
7 mA typically
8 ms typically
8 ms typically
*)Negativevoltageisrestrictedbytheprotectivediode(I
max
= 0.5 A)
Technical data on outputs
Number of outputs: 6 (2 + 4) electrically connected
Source operation, not short circuit protected,
Current: 5…500 mA steady load
Voltage range: 5…32 VDC*)
Voltage drop: < 0.3 V at 500 mA for I6 und I7
< 0.7 V at 500 mA for I/O2…I/O5
Total current per module: 3 A steady load
Switch-on delay: 10 µs typ.
Switch-o󰀨delay: 50 µs typ. (100 µs max.), (ohmic load 5…500 mA), longer for
inductive load because of protective diode.
*)Ifthestateofacombinedoutputistobereado󰀨,voltageU
ext
must be at least 17 VDC,
as the state and the LED are displayed via the input.