SBC PCD2 Series - Page 276

Saia-Burgess Controls AG
Manual I/O-modules for PCD1 │ PCD2 series │ Document 27-600 – Release ENG09 │ 2019-05-01
7-2
PCD2.B160 & PCD3.B160
Module Overview | Hardware
7
7 PCD2.B160 & PCD3.B160
7.1 Module Overview
Thecongurabledigitalin-andoutputmoduleo󰀨ersonsmallestspacethepossibility
tocongure16I/Osingroupsoffoureitherasin-orasoutput.
In terms of expandability and maximum space usage this modules leaves no wishes
■ Module current consumption: 120 mA from the +5V Bus
■ Input: typ. 24 VDC
■ Inputlter:0.2/8mscongurable
■ Galvanic isolation: none
■ Outputs: 0.25 A / 18 …30 VDC
■ Protection against short circuit
■ I/O connector type K
■ CongurationwithPG5DeviceCongurator(ServicePack2)
Compatibility:
■ FW 1.16.52 or higher
■ PG52.0o󰀩cialreleasePG5V2.0.210orhigher
■ Supported platforms PCD3, PCD2.M5_ and PCD1.M2_
7.2 Hardware
ThecongurationoftheI/Oisdoneingroupsoffour.
Following combinations are possible:
16O/0I, 12O/4I, 8O/8I, 4O/12I, 0O/16I
The I/O module can be placed on any slot of a PCD1.M2_, PCD2.M5_, PCD3.M and
their corresponding IO-Extension modules (except slot 15 because of the watch dog -
I/O address 255).