Appendix 1 Parameter table
Appendix 189
Zero current detection time
Programmed operation minute /
second selection
0: Select minute as the time increment.
1: Select second as the time increment.
Run direction in each section
Programmed operation cycle
selection
1~8: Start cycle from the set section.
Programmed operation
acceleration / deceleration time
setting selection
0: Acceleration time is 01-06(P.7), deceleration
time is 01-07(P.8).
1: Acceleration and deceleration time is set by
04-35(P.111)~04-42(P.118).
Programmed operation mode
speed 1
Programmed operation mode
speed 2
Programmed operation mode
speed 3
Programmed operation mode
speed 4
Programmed operation mode
speed 5
Programmed operation mode
speed 6
Programmed operation mode
speed 7
Programmed operation mode
speed 8