Preparing the Engineering
248 Unrestricted SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual
DC8-037-2.02, Edition 10.2017
7.5 Memory Cards
7.5.1 SD Card
For the storage of engineering data CP-8000/CP-802x needs an SD card. This resides in the
slot at the housing front (CP-8000) or housing back (CP-802x), refer to section 6.6.1, SD
Card.
With delivery of CP-8000/CP-802x, all required files for the correct operation are stored in
folders on the SD card:
• Firmware SICAM WEB (short text: SWEB00), binary file: SCD-001-1_xy.web
• The Web files for SICAM WEB are unzipped on the SD card in the folder SYS-
TEM\SICWEB
• The master data for SICAM WEB are unzipped on the SD card in the subfolders of SYS-
TEM\SICWEB\FW
• Firmware of the device (CPC80), binary file: SC8-080-1_xy.bin
• Optional firmwares for protocol and peripherals
With usage of another suitable SD card, please consider the instruction in section 11.4.4, Re-
placement of the SD Card.
7.5.1.1 SD Card Reader/Writer
For archiving purposes, the engineering data and firmwares stored on the SD card can be
read with a standard commercial SD card reader/writer and be stored on a PC. On the other
hand, in particular for the initialization of a target device, the data can be written from a PC to
the SD card.
If needed, a driver software required for the use of the SD card reader/writer must be installed
on the PC. Follow thereto the instructions of the manufacturer.
For the formatting of the SD card the formatting tool SD Card Formatter must be used
(https://www.sdcard.org/downloads/formatter_4/). The SD card must be formatted with the file
system FAT16.
7.5.2 SIM Card (only CP-8022)
For the communication via GPRS you need a mobile network provider. This supplies a SIM
card (choose the standard format = Mini SIM). The SIM card must be put in the slot at the
housing front, refer to section 6.6.2, SIM Card.
To Next Page
Loading...
Need help?
General
