Engineering via SICAM WEB
450 Unrestricted SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual
DC8-037-2.02, Edition 10.2017
9.3.2 Download Device Settings
This function enables to save the entire engineering data of the target device as a backup on
the engineering PC. The backup contains firmware codes and engineering data (parameters
and – if present - instruction list).
Select thereto the submenu Backup device settings .
The following dialog will appear:
You have the possibility to abort the procedure.
• Confirm the procedure with
If settings still have not been saved, the following dialog will appear:
You have to abort the procedure and save the changes.
If the settings have been saved, the target device starts with the generation of the backup file.
The progress is thereby displayed by the web server. This procedure can take a few minutes.
Note
During generation procedures the website must not be left. The selection of another website may lead to
the occurrence of undefined states.
To Next Page
Loading...
Need help?
General
