Engineering via SICAM TOOLBOX II
286 Unrestricted SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual
DC8-037-2.02, Edition 10.2017
8.1.1 Presets
Before you begin with the engineering of CP-8000/CP-802x, several basic settings are to be
carried out for the work with the SICAM TOOLBOX II:
• User and rights
─ User-specific settings
• Password
• Workplace-secific settings
• Organization of the SICAM TOOLBOX II
• Language
For the access to the SICAM TOOLBOX II a logon with username and password is required.
The parameterization with the SICAM TOOLBOX II happens exclusively offline. Only the
transfer of data (firmware, application data), as well as test and diagnosis are performed
online via a communication connection.
The globally valid configuration parameters in the SICAM TOOLBOX II are displayed and set
with the tool “TOOLBOX II Presets”. They can – dependent on the access rights – be changed
at any optional time.
You find the details thereto in the SICAM TOOLBOX II Online Help, chapter “TOOLBOX II
Presets” and chapter “Administration of TOOLBOX II”.
8.1.1.1 User and Rights
The following user names are predefined and can be selected. For each user name different
rights are predefined.
• Type admin
• Type profi
• Type standard
As user name admin you can freely assign new user names (max. 8 characters). For each
user a special role (max. 20 characters) can be assigned.
For each role certain rights can be freely selected and assigned from a list. Depending on
which role a user has been assigned, he may control determined functions. An exception are
the unchangeable roles, that are reserved for the Siemens specialists for maintenance pur-
poses.
You find the details thereto in the SICAM TOOLBOX II Online Help, chapter “TOOLBOX II
Presets”, section “User/Role Administration”.
Note
All operation and test functions of CP-8000/CP-802x described in this manual are generally applicable for
the admin role available in the SICAM TOOLBOX II.
Note
From SICAM TOOLBOX II V5.11 it is possible to create domain use
rs. Such a domain user does not use a
specific SICAM TOOLBOX II user role to start SICAM TOOLBOX II, but he uses the user account for the
logon on his workstation.
To Next Page
Loading...
Need help?
General
