Engineering via SICAM WEB
SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual Unrestricted 403
DC8-037-2.02, Edition 10.2017
9.1.11.5.6 Binary Information Output
For the output of binary information a digital output module must be equipped, and the DO
signals to be used must be configured.
With the parameter Fail_behav you can determine the behavior of a binary information
output upon failure of the Master Module. You find further information thereto in the manual
SICAM RTUs Common Functions Peripheral Elements According to IEC 60870-5-101/104,
chapter "Binary Information Output", section "Deactivation or Retention on Failure".
9.1.11.5.7 Current/Voltage Output
For the output of currents or Voltages an analog output module must be equipped, and the AO
signals to be used must be configured.
With the parameter Fail_behav you can determine the behavior of a binary information
output upon failure of the Master Module. You find further information thereto in the manual
SICAM RTUs Common Functions Peripheral Elements According to IEC 60870-5-101/104,
chapter "Binary Information Output", section "Deactivation or Retention on Failure".
To Next Page
Loading...
