Set Up Dial-Up Connection on Engineering PC
586 Unrestricted SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual
DC8-037-2.02, Edition 10.2017
D.4 Restore Settings for the Internet Use
Note
The new dial up connection is now the default connection which is activated if the web browser is called. If
the web browser was used before for browsing the internet, this does not work now any more.
In order to use the web browser further for browsing the internet, you must modify the new dial
up connection as follows (the following steps are exemplary and depend on the respective
operating system of the engineering PC):
• Open via the start menu the Control Panel
• Depending on the display select Network and Internet, and then Internet Options
• Select the register tab CONNECTIONS
• Mark the option NEVER DIAL A CONNECTION and confirm with OK
Now you can use the web browser again for browsing the internet.
Note
In order to set up a connection to SICAM MIC now, you must start at first the new dial up connection
manually, and afterwards you can connect with the respective target device.
To Next Page
Loading...
Need help?
General
