Engineering via SICAM WEB
454 Unrestricted SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual
DC8-037-2.02, Edition 10.2017
The file selection dialog for the source is opened:
• Select now the source directory and the source file of the type *.cmc and accept
The file selection dialog for the target is opened:
• Select the target drive (read/write device) and accept
Sicam_first_startup generates the files with the format needed for the web server from the pa-
rameter file and stores them on the SD card. The generation terminates with a notification.
The write procedure takes a few seconds (watch the Active-LED on the read/write device, as
far as present). When the write procedure is completed, you can insert the SD card into the
target device, whereupon a startup is performed.
After the startup you can logon to the target device via SICAM WEB, for instance to adapt the
parameterization or to carry out test functions.
Note
With operation in a network first a valid IP address must be assigned by means of the program
Sicam_first_startup.
To Next Page
Loading...
Need help?
General
