Siemens FST020 - Enable Alarms; Sensor Events (1); Sensor Events (2); Process Events (1)

Maintenance and diagnostics
4.2 Diagnostic events
FST020 Function manual
Function Manual, 09/2017, A5E42949526-AA
131
4.2.7
Enable alarms
4.2.7.1
Sensor events (1)
Description
Various sensor alarms can be enabled to show in the display and on the output if they occur.
Setting 05 DSL voltages; 06 DSL storage; 07 Flow measurement; 08 DSL internal; 14 Path 1: No
Signal; 15 Path 2: No signal; 16 Path 3: No signal; 17 Path : No signal; 19 Electronics
temp.; 22 Density calculation; 23 Medium temp. calc.; 24 Pressure calculation; 25 Viscosity
calculation; 26 Sensor temp. comp.; 28 Configuration 1; 31 Sensor temp.
Default
-
Related
The selected events will be shown in the display when they occur. Furthermore, they will be
indicated on the output if
Output (2)
,
Input/output (3)
and/or
Input/output (4)
is set to Status
output and
Status mode
is set to Alarm item.
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Sensor events (1)
4.2.7.2
Sensor events (2)
Description
Various sensor alarms can be enabled to show in the display and on the output if they occur.
Setting
34 Invalid flow meas.; 36 Configuration 2; 37 DSL system monitor
Default
-
Related
The selected events will be shown in the display when they occur. Furthermore, they will be
indicated on the output if
Output (2)
,
Input/output (3)
and/or
Input/output (4)
is set to Status
output and
Status mode
is set to Alarm item.
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Sensor events (2)
4.2.7.3
Process events (1)
Description
Various sensor alarms can be enabled to show in the display and on the output if they occur.