Siemens FST020 - Process Events (4); Totalizer Events; Device Events

Maintenance and diagnostics
4.2 Diagnostic events
FST020 Function manual
Function Manual, 09/2017, A5E42949526-AA
133
Related
The selected events will be shown in the display when they occur. Furthermore, they will be
indicated on the output if
Output (2)
,
Input/output (3)
and/or
Input/output (4)
is set to Status
output and
Status mode
is set to Alarm item.
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Process events (3)
4.2.7.6
Process events (4)
Description
Various sensor alarms can be enabled to show in the display and on the output if they occur.
Setting
Various process alarms selectable
Default
-
Related
The selected events will be shown in the display when they occur. Furthermore, they will be
indicated on the output if
Output (2)
,
Input/output (3)
and/or
Input/output (4)
is set to Status
output and
Status mode
is set to Alarm item.
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Process events (4)
4.2.7.7
Totalizer events
Description
Various sensor alarms can be enabled to show in the display and on the output if they occur.
Setting
136 Totalizer 1 above alarm limit; 137 Totalizer 1 above warning limit; 138 Totalizer 1 be-
low warning limit; 139 Totalizer 1 below alarm limit
Default
Related
The selected events will be shown in the display when they occur. Furthermore, they will be
indicated on the output if
Output (2)
,
Input/output (3)
and/or
Input/output (4)
is set to Status
output and
Status mode
is set to Alarm item.
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Totalizer events
4.2.7.8
Device events
Description
If one of the selected events appears this affects the status icon, the related status output
and the alarm on the communication interface.