Siemens FST020 - Capacity Available (Read Only); Data Logging; Activation; Data Logging Mode

Maintenance and diagnostics
4.7 SensorFlash
FST020 Function manual
Function Manual, 09/2017, A5E42949526-AA
157
4.7.4
Capacity available (read only)
Description
Free capacity of installed SensorFlash.
Shows INSERT CARD if card is not installed.
Setting
Default
GB
Related
Path
Maintenance and diagnostics → SensorFlash → Capacity available
4.7.5
Data logging
4.7.5.1
Activation
Description
Activation - turns on and off data logging activation
Setting
Off; On
Default
Off
Related
If this parameter is set to Enabled, the parameters
Logging value 1
through
Logging value 20
can be configured.
Path
Maintenance and diagnostics → SensorFlash → Data logging → Activation
4.7.5.2
Data logging mode
Description
Select between a momentary value or an averaged value calculated over one logging
interval.
Setting
Log instantaneous, Log average value
Default
Log instantaneous
Related
Path
Maintenance and diagnostics → SensorFlash → Data logging → Data logging mode