Siemens FST020 - Alarm Class; Audit Trail; Parameter Change Log; Clear Parameter Change Log (Write Only)

Maintenance and diagnostics
4.9 Audit trail
FST020 Function manual
Function Manual, 09/2017, A5E42949526-AA
169
Setting Maintenance alarm; Function check; Process value alarm; Process value warning; Mainte-
nance warning; Maintenance required
Default
None selected
Related
This parameter can only be accessed if
Status icons
is set to Standard.
Path
Maintenance and diagnostics → Simulation → Simulation alarms → Alarm class
4.8.3.4
Alarm class
Description
The NAMUR alarm class to be simulated can be configured. The alarm status is activated on
all outputs.
Setting
Failure; Function check; Out of specification; Maintenance required
Default None selected
Related
This parameter can only be accessed if
Status icons
is set to NAMUR.
Path
Maintenance and diagnostics → Simulation → Simulation alarms → Alarm class
4.9
Audit trail
4.9.1
Parameter change log
Displays list of logged parameter changes. (Log shows parameter value before the change,
not the current value.)
Path
Maintenance and diagnostics → Audit trail → Parameter change log
4.9.2
Clear parameter change log (write only)
Description
The parameter change log can be reset using this parameter.
Setting
Cancel; Ok
Default
Cancel