Siemens FST020 - Custom Conversion Factor; Decimal Places; Low Flow Cut-Off

Setup
3.2 Process values
FST020 Function manual
Function Manual, 09/2017, A5E42949526-AA
45
Setting
-
Default
-
Related
Path
Setup → Process values → Flow velocity → Custom units
3.2.3.3
Custom conversion factor
Description
Conversion factor for custom unit flow velocity values based on SI velocity units m/s.
Setting
-
Default
1.0
Related
Path
Setup → Process values → Flow velocity → Custom conversion factor
3.2.3.4
Decimal places
Description
Sets the decimal places for the process value displayed in the local display.
Setting
Auto; No decimal place; 1 decimal place; 2 decimal places; 3 decimal places; 4 decimal
places; 5 decimal places; 6 decimal places
Default
2 decimal places
Related
Path
Setup → Process values → Flow velocity → Decimal places
3.2.3.5
Low flow cut-off
Description
Flow velocity limit for low flow cut off. Below limit flow velocity output is forced to zero.
Setting
Min 0.00
Default
0.0 m/s
Related
Path
Setup → Process values → Flow velocity → Low flow cut-off