Siemens FST020 - Path Settings; Installed Paths; Path 1

Setup
3.1 Sensor settings
FST020 Function manual
Function Manual, 09/2017, A5E42949526-AA
29
3.1.7
Path settings
3.1.7.1
Installed paths
Description
Bit encoded value containing installed paths for clamp-on systems.
Bit 0: Path 1 installed
Setting
0 to 31
Default
0
Related
Path
Setup → Sensor settings → Path settings → Installed paths
3.1.7.2
Path 1
3.1.7.2.1 Sensor frequency
Description
Desired sensor frequency for path 1. Read only.
Setting
80000.0 Hz to 4000000.0 Hz
Default
Related
Path
Setup → Sensor settings → Path settings → Path 1 → Sensor frequency
3.1.7.2.2 Path geometry
Description
The number of crossings the signal makes through the pipe (Reflect or Direct geometry for
Path 1).
For example:
Direct (1 traverse)
Reflect (2 traverse)
Direct (3 traverse)
Reflect (4 traverse)
Setting
1 to 10
Default
1