Siemens FST020 - Simulation Events (1); Simulation Events (2)

Maintenance and diagnostics
4.2 Diagnostic events
FST020 Function manual
134 Function Manual, 09/2017, A5E42949526-AA
Setting 148 Transm. temp. above alarm limit; 149 Transm. temp. below alarm limit; 150 Sensor
signal disruption; 159 Internal error in transmitter
Default
Related
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Device events
4.2.7.9
Simulation events (1)
Description
Various sensor alarms can be enabled to show in the display and on the output if they occur.
Setting
160 Mass flow simulated; 161 Volume flow simulated; 162 Density simulated; 163 Medium
temp. simulated; 167 Totalizer 1 simulated
Default
Related
The selected events will be shown in the display when they occur. Furthermore, they will be
indicated on the output if
Output (2)
,
Input/output (3)
and/or
Input/output (4)
is set to Status
output and
Status mode
is set to Alarm item.
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Simulation events
(1)
4.2.7.10
Simulation events (2)
Description
Various sensor alarms can be enabled to show in the display and on the output if they occur.
Setting
289 Sound velocity simulated; 290 Flow velocity simulated; 292 Kin. viscosity simulated
Default
Related
The selected events will be shown in the display when they occur. Furthermore, they will be
indicated on the output if
Output (2)
,
Input/output (3)
and/or
Input/output (4)
is set to Status
output and
Status mode
is set to Alarm item.
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Simulation events
(2)