Siemens FST020 - Modbus (Channel 1); Slave Address (SW); Slave Address (HW) (Read Only); Baud Rate

Communication
5.2 Modbus (Channel 1)
FST020 Function manual
174 Function Manual, 09/2017, A5E42949526-AA
Related
Path
Communications → Service channel (USB) → MSD connect
5.2
Modbus (Channel 1)
5.2.1
Slave address (SW)
Description
The slave address (SW) for the Modbus device can be configured. This address is used if
the DIP switch is set to 0.
Setting 1 to 247
Default
Related
Path
Communication → Modbus (Channel 1) → Slave address (SW)
5.2.2
Slave address (HW) (read only)
Description
The slave address (HW is determined by the DIP switch setting on the transmitter cassette
and can be read out in this parameter. This address is used if the DIP switch is set to a value
> 0.
Options
Read only
Related
Path
Communication → Modbus (Channel 1) → Slave address (HW)
5.2.3
Baud rate
Description
Baud rate of Modbus interface.
Setting
9600 Bit/s; 19200 Bit/s; 115200 Bit/s; 38400 Bit/s; 57600 Bit/s; 76800 Bit/s; 1200 Bit/s;
2400 Bit/s; 4800 Bit/s
Default