Siemens FST020 - Custom Conversion Factor; Decimal Places; Low Flow Cut-Off

Setup
3.2 Process values
FST020 Function manual
42 Function Manual, 09/2017, A5E42949526-AA
Setting
-
Default
-
Related
Path
Setup → Process values → Mass flow → Custom units
3.2.2.3
Custom conversion factor
Description
User specific conversion factor based on SI mass flow units kg/s.
Setting
-
Default
1.0
Related
Path
Setup → Process values → Mass flow → Custom conversion factor
3.2.2.4
Decimal places
Description
Sets the decimal places for the process value displayed in the local display.
Setting
Auto; No decimal place; 1 decimal place; 2 decimal places; 3 decimal places; 4 decimal
places; 5 decimal places; 6 decimal places
Default
2 decimal places
Related
Path
Setup → Process values → Mass flow → Decimal places
3.2.2.5
Low flow cut-off
Description
Mass flow limit for low flow cut off. Below limit mass flow output is forced to zero.
Setting
0.00 to 3682800.00 kg/h (depends on sensor)
Default
0.1% of maximum mass flow (depends on sensor)
Related
Path
Setup → Process values → Mass flow → Low flow cut-off