Siemens FST020 - Medium Temperature; Simulate Alarms; Simulation Mode

Maintenance and diagnostics
4.8 Simulation
FST020 Function manual
Function Manual, 09/2017, A5E42949526-AA
165
Setting
The range is shown as minimum and maximum values in the HMI.
Default
0.000001 m
2
/s
Related
Only if Kinematic viscosity is marked in
Enable simulation
, then the setting of this parameter
will be relevant.
The range and default setting are dependent on the selected
Unit.
Path
Maintenance and diagnostics → Simulation → Simulation process values → Kinematic vis-
cosity → Simulation value
4.8.2.8
Medium temperature
Simulation value
Description
Set the Medium temperature value to be simulated.
Setting
-273.0 °C (-459.399994 °F) to +400.0 °C (752.0 °F)
Default 20.0 °C (68 °F)
Related
Only if Medium temperature is marked in
Enable simulation
, then the setting of this
parameter
will be relevant.
The range and default setting are dependent on the selected
Unit.
Path
Maintenance and diagnostics → Simulation → Simulation process values → Medium tem-
perature → Simulation value
4.8.3
Simulate alarms
4.8.3.1
Simulation mode
Description
The alarm simulation mode can be configured in this parameter.
Setting
Off; Simulate alarm (ID number); Simulate alarm class
Default
Off