Commissioning
6.3 Commissioning using the STARTER commissioning tool
SINAMICS DCP
Operating Instructions, 09/2019, A5E34382853K
131
Note
To parameterize the interfa
ce, you must install the appropriate interface card (e.g.: PC
We recommend that the Siemens USB PROFIBUS CP5711 adapter is used, Article number
6GK1571
-1AA00.
Figure 6-7 Setting up the interface - properties
Note
PG/PC is the only master on bus
must be activated if no other masters (PC, S7, etc.) are
bus.
Note
Even if no PROFIBUS interface is installed in the PC, projects can be generated and
PROFIBUS addresses for the drive objects can be assigned.
Only the bus addresses available in the project will be offered. That prevents double bus
address a
ssignments.
⇒ After completion, click OK to confirm the setup and to return to the project wizard.
To Next Page
Loading...
