Siemens sinamics dcp - Page 134

Commissioning
6.3 Commissioning using the STARTER commissioning tool
SINAMICS DCP
132 Operating Instructions, 09/2019, A5E34382853K
Figure 6-8 Setting the interface - ready
⇒ Click Next > to set a drive unit in the project wizard.
Figure 6-9 Inserting the drive unit
⇒ Select the following data from the list fields:
Unit:
SINAMICS DCP
Type:
DCP Advanced CUD
Version:
Current version
Bus address:
The corresponding drive bus address (the default setting is 0)
Name:
Any desired name can be entered in the name box