Commissioning
6.5 Commissioning optional additional modules
SINAMICS DCP
Operating Instructions, 09/2019, A5E34382853K
151
Before the module can also be addressed in the network, an IP address and device name
must be assigned, see Chapter "Communication via PROFINET IO (Page 246)".
Note
If PROFINET is to be used only as a commissioning interface but process control is through
PROFIBUS
, after commissioning the CBE20, the process data interface needs to be set
back to PROFIBUS (p8839 = 1).
Adding offline in STARTER
Figure 6-25 Configuration
To Next Page
Loading...
