Siemens sinamics dcp - Page 174

Operation
7.1 Operation
SINAMICS DCP
172 Operating Instructions, 09/2019, A5E34382853K
Information on the keys
Table 7- 5 Keys
Key
Name
Meaning
ON Switching on
Binector output r0019.0 is set using this key.
OFF Switching off
The binector outputs r0019.0, .1 and .2 are simultaneously reset when this key is pressed. After
the key has been released, binector outputs r0019.1 and .2 are again set to a "1" signal.
Note
:
The effectiveness of these keys can be defined via BICO parameterization.
Functions The meaning of these keys depends on the current display.
Note
:
The effectiveness of this key to acknowledge faults can be defined via BICO parameterization.
Parameters The meaning of these keys depends on the current display.
If this key is pressed for 3 s, the "Copy RAM to ROM" function is executed. The "S" displayed on
the BOP disappears.
Higher The keys depend on the current display and are used to either increase or decrease values.
Lower