Operation
7.1 Operation
SINAMICS DCP
174 Operating Instructions, 09/2019, A5E34382853K
Drive object, Control Unit (CU_DCP)
● r0002 Control Unit status display
● p0003 BOP access level
● p0004 BOP display filter
● p0007 BOP background lighting
● p0008 BOP drive object after running up
● p0009 Device commissioning, parameter filter
● p0011 BOP password input (p0013)
● p0012 BOP password confirmation (p0013)
● r0019 CO/BO: Control word, BOP
● p0977 Save all parameters
Note
During a data save operation initiated by the user, the electronics power supply for
the
SINAMICS DCP must not be interrupted.
An active data save operation is indicated by the following actions:
The RDY-LED flashes (see Chapter "Description of the LEDs on the CUD
(Page 362)")
The BOP20 flashes
Interrupting the electronics power supply while saving can lead to the loss of the current
device parameter assi
gnment. See also Chapter "Memory card functions (Page 158)".
Drive object (DCP_CTRL)
● p0010 Drive commissioning parameter filter
To Next Page
Loading...
