Operation
7.4 Communication according to PROFIdrive
SINAMICS DCP
186 Operating Instructions, 09/2019, A5E34382853K
Connecting the PC to the STARTER commissioning tool
You can go online with STARTER in a number of ways, which are illustrated below:
Figure 7-15 Connecting the supervisor
Note
SINAMICS does not support routing from PROFIBUS to PROFINET and vice versa.
Note
If a CBE20 Communication Board Ethernet fails (e.g. due to a power failure), then
communication with the subsequent nodes i
s interrupted at this point.
To Next Page
Loading...
