Siemens sinamics dcp - Page 205

Operation
7.4 Communication according to PROFIdrive
SINAMICS DCP
Operating Instructions, 09/2019, A5E34382853K
203
Error
value
Meaning
Remark
Additional
info
7B hex Parameter %s [%s]: Write access
only in the commissioning state,
device configuration (de-
vice: p0009 = 1).
– –
7C hex Parameter %s [%s]: Write access
only in the commissioning state,
device download (de-
vice: p0009 = 29).
– –
7D hex Parameter %s [%s]: Write access
only in the commissioning state,
device parameter reset (de-
vice: p0009 = 30).
– –
7E hex Parameter %s [%s]: Write access
only in the commissioning state,
device ready (device: p0009 = 0).
– –
7F hex Parameter %s [%s]: Write access
only in the commissioning state,
device (device: p0009 not equal to 0).
– –
81 hex Parameter %s [%s] must not be writ-
ten during download.
– –
82 hex Transfer of master control is blocked
by BI: p0806.
– –
83 hex Parameter %s [%s]: Requested BICO
interconnection not possible.
BICO output does not supply float values. The BICO input,
however, requires a float value.
–
84 hex Parameter %s [%s]: Parameter
change inhibited
(refer to p0300, p0400, p0922)
– –
85 hex Parameter %s [%s]: Access method
not defined.
– –
87 hex Write job will not be executed. The write request is rejected because know-how protection
is active.
–
C8 hex Below currently valid limit. Modification request for a value that, although within "abso-
lute" limits, is below the currently valid lower limit.
–
C9 hex Above currently valid limit. Modification request for a value that, although within "abso-
lute" limits, is below the currently valid lower limit (e.g. gov-
erned by the current converter rating).
–
CC hex Write access not permitted. Write access is not permitted because an access code is not
available.
–