Siemens sinamics dcp - Page 204

Operation
7.4 Communication according to PROFIdrive
SINAMICS DCP
202 Operating Instructions, 09/2019, A5E34382853K
Error
value
Meaning
Remark
Additional
info
6B hex Write access for enabled controller. Write access is possible while the device is in the "Controller
enable" state.
Pay attention to the parameter attribute "changeable" in the
SINAMICS S120/S150 List Manual (C1, C2, U, T).
–
6C hex Parameter %s [%s]: Unknown unit. – –
6D hex Parameter %s [%s]: Write access
only in the commissioning state,
encoder (p0010 = 4).
– –
6E hex Parameter %s [%s]: Write access
only in the commissioning state,
motor (p0010 = 3).
– –
6F hex Parameter %s [%s]: Write access
only in the commissioning state,
power unit (p0010 = 2).
– –
70 hex Parameter %s [%s]: Write access
only in the quick commissioning
mode (p0010 = 1).
– –
71 hex Parameter %s [%s]: Write access
only in the ready mode (p0010 = 0).
– –
72 hex Parameter %s [%s]: Write access
only in the commissioning state,
parameter reset (p0010 = 30).
– –
73 hex Parameter %s [%s]: Write access
only in the commissioning state,
Safety (p0010 = 95).
– –
74 hex Parameter %s [%s]: Write access
only in the commissioning state, tech.
application/units (p0010 = 5).
– –
75 hex Parameter %s [%s]: Write access
only in the commissioning state
(p0010 not equal to 0).
– –
76 hex Parameter %s [%s]: Write access
only in the commissioning state,
download (p0010 = 29).
– –
77 hex Parameter %s [%s] must not be writ-
ten during download.
– –
78 hex Parameter %s [%s]: Write access
only in the commissioning state, drive
configuration (device: p0009 = 3).
– –
79 hex Parameter %s [%s]: Write access
only in the commissioning state,
define drive type (device: p0009 = 2).
– –
7A hex Parameter %s [%s]: Write access
only in the commissioning state, data
record base configuration (de-
vice: p0009 = 4).
– –