Operation
7.6 Communication via PROFINET IO
SINAMICS DCP
Operating Instructions, 09/2019, A5E34382853K
257
Setting the IP address in Windows 7
g procedure is based on the Windows 7 operating system. With other operating
systems (such as Windows XP or Windows
10), operation may differ slightly.
1. In the PG/PC call the control panel using the "Start > Control Panel" menu item.
2. In the control panel of your PG/PC, under "Network and Internet", select the "Network and
Sharing Center" function.
3. For your network card that is displayed, click the connection link.
4. Click in the status dialog of the connection on "Properties" and acknowledge the
subsequent confirmation prompt with "Yes".
5. In the properties dialog of the connection, select the "Internet protocol 4 (TCP/IPv4)"
element and then click "Properties".
6. In the properties dialog, activate the "Use the following IP address" option.
7. Set the IP address of the PG/PC access interface of the Control Unit to 169.254.11.1 and
the subnet mask to 255.255.0.0.
Figure 7-40 Properties of the Internet protocol (TCP/IP)
8. Click "OK" and close the Windows-specific window of the network connections.
To Next Page
Loading...
