Operation
7.6 Communication via PROFINET IO
SINAMICS DCP
258 Operating Instructions, 09/2019, A5E34382853K
Setting the interface in STARTER
In STARTER, you set communication via PROFINET as follows:
1. Call the menu "Tools > Set PG/PC interface ...".
2. Select the "Access point of the application", and therefore the interface parameter
assignment (in the example we use the access point "S7ONLINE (STEP 7)" and the
interface parameterization "TCP/IP(Auto)->Belkin F5D 5055").
Figure 7-41 Setting the PG/PC interface
If the desired interface does not yet exist in the selection list, you can create it.
To Next Page
Loading...
