Siemens sinamics dcp - Page 306

Operation
7.8 Communication via EtherNet/IP (EIP)
SINAMICS DCP
304 Operating Instructions, 09/2019, A5E34382853K
Attribute ID
Service
Type
Name
Value/explanation
5 get,
get_and_cle
ar
Struct of
Media Counters
Media-specific counters
UINT32 Alignment Errors Structure received, which does not match the
number of octets
UINT32 FCS Errors Structure received, which does not pass the FCS
check
UINT32 Single Collisions Structure successfully transmitted, precisely one
collision
UINT32 Multiple Collisions Structure successfully transmitted, several colli-
sions
UINT32
SQE Test Errors
Number of SQE errors
UINT32
Deferred Transmissions
First transmission attempt delayed
UINT32 Late Collisions Number of collisions that occurred delayed by
512 bit timers to the request
UINT32 Excessive Collisions Transmission unsuccessful as a result of inten-
sive collisions
UINT32 MAC Transmit Errors Transmission unsuccessful as a result of an in-
ternal MAC sublayer transmission error.
UINT32 Carrier Sense Errors Number of errors when attempting to send a
request frame, where the transmission condition
was lost or was not assigned
UINT32
Frame Too Long
Structure too large
UINT32 MAC Receive Errors Transmission unsuccessful as a result of an in-
ternal MAC sublayer receive error.
6 get, set
Struct of
Interface Control
-
UINT16 Control Bits -
UINT16
Forced Interface Speed
-
10
get
String
Interface_Label
Interface-Label
11 get - Interface Capability Bit 0: Manual setting
Bit 1: Auto negotiate
Bit 2: Auto MDIX
Bit 3: Manual speed/duplex
Bits 4 – 31: reserved
Rest: Speed/Duplex options