Siemens sinamics dcp - Page 337

Operation
7.11 Closed-loop control
SINAMICS DCP
Operating Instructions, 09/2019, A5E34382853K
335
A recovery time after 150 % overload with various currents below the rated current is
shown in the following diagram as example:
Figure 7-66 "High overload" load cycle - example of a recovery process after 150 % overload
Note
The 30 kW de
vice only supports the "Increased current" load profile. This is the reason that
only settings p55081
= 0, 1 are permissible.
When selecting a load profile that is not permitted, when switching on (p0840
= 1) fault
F60058 is output.
The fault is immediatel
y output if the device is operational when the selection is made.