Why does my Siemens Temperature Controller show an electronics temperature alarm?
If your Siemens Temperature Controller displays 'Electronics temperature alarm', it means the device is operated outside its specified temperature range. Check the operating temperature.
What does 'Drift detected, ground voltage offset to terminal 3' mean on my Siemens SITRANS TSinsert Temperature Controller?
If your Siemens Temperature Controller displays 'Drift detected, ground voltage offset to terminal 3', it means a critical measurement error is detected on ground voltage offset to terminal 3. Reconnect or repair the sensor. If the problem persists, contact Technical Support.
What does 'Primary variable out of limits' mean on my Siemens Temperature Controller?
If your Siemens Temperature Controller displays 'Primary variable out of limits', it means the process value has reached the sensor limit. Review process conditions versus product specifications.
How to fix 'Loop current read back error' on Siemens SITRANS TSinsert Temperature Controller?
If your Siemens Temperature Controller displays 'Loop current read back error' because the loop current does not correspond to the expected value, check DAC trim settings and restore to factory DAC calibration.
What to do if Siemens SITRANS TSinsert Temperature Controller displays 'Volatile memory check failure Maintenance alarm'?
If your Siemens Temperature Controller displays 'Volatile memory check failure Maintenance alarm' because of a device electronics error, restart the device. If the error continues, the device electronics may have a defect. Repair is required. Contact Technical Support.
How to fix 'CRC16 error in input CPU configuration' on Siemens Temperature Controller?
If your Siemens Temperature Controller displays 'CRC16 error in input CPU configuration', reset the device or switch it off and back on.
How to troubleshoot a Siemens Temperature Controller failure related to hardware configuration?
If your Siemens Temperature Controller displays 'Failure' due to parameter setting, connection error, or configuration error in the hardware, check the hardware configuration of the device using the HMI or engineering system.
What to do if Siemens SITRANS TSinsert shows 'Function test' due to incomplete safety validation?
If your Siemens Temperature Controller displays 'Function test' because safety validation is not complete, acknowledge the safety event in the Functional Safety menu and repeat safety commissioning.
Why does my Siemens SITRANS TSinsert Temperature Controller show out of specification?
If your Siemens Temperature Controller indicates 'Out of specification', it means the device has detected deviations from permissible ambient or process conditions. Check the ambient temperature or process conditions, and if possible, install the device at a different location.
Why does my Siemens Temperature Controller display 'No symbol is displayed' when the device state is ok?
If your Siemens Temperature Controller displays 'No symbol is displayed' and the device state is ok with no errors from active diagnostics, no action is required.
General| Communication Protocol | HART |
|---|---|
| Type | Temperature Transmitter |
| Output Signal | 4 to 20 mA, HART |
| Sensor | RTD, Thermocouple |
| Inputs | RTD, Thermocouple |
| Operating Temperature | -40 to 85 °C (-40 to 185 °F) |
| Protection Class | IP67 |
| Display | Optional LCD display |
To Next Page
