Why does my Siemens Temperature Controller show an electronics temperature alarm?
If your Siemens Temperature Controller displays 'Electronics temperature alarm', it means the device is operated outside its specified temperature range. Check the operating temperature.
How to fix 'Input 1 error' on Siemens SITRANS TSinsert Temperature Controller?
If your Siemens Temperature Controller displays 'Input 1 error', it means a sensor error (broken/shorted sensor) is detected at Input 1. Unplug and reconnect the sensor cable. If the problem persists, replace the sensor.
How to fix 'Input 2 error' on Siemens SITRANS TSinsert?
If your Siemens Temperature Controller displays 'Input 2 error', it means a sensor error (broken/shorted sensor) is detected at Input 2. Unplug and reconnect the sensor cable. If the problem persists, replace the sensor.
What does 'Input 1 CJC error' mean on my Siemens Temperature Controller?
If your Siemens Temperature Controller displays 'Input 1 CJC error', it means a sensor error (broken/shorted sensor) is detected at the cold junction compensation measurement used for Input 1. Unplug and reconnect the sensor cable. If the problem persists, replace the sensor.
What does 'Input 2 CJC' mean on my Siemens SITRANS TSinsert?
If your Siemens Temperature Controller displays 'Input 2 CJC', it means a sensor error (broken/shorted sensor) is detected at the cold junction compensation measurement used for Input 2. Unplug and reconnect the sensor cable. If the problem persists, replace the sensor.
What does 'Drift detected' mean on my Siemens SITRANS TSinsert?
If your Siemens Temperature Controller displays 'Drift detected', it means the difference of the measured results between Input 1 and Input 2 lies above the configured maximum limit. Unplug and reconnect the sensor cable. If the problem persists, replace the sensor.
Why is 'Backup enabled' on my Siemens SITRANS TSinsert Temperature Controller?
If your Siemens Temperature Controller displays 'Backup enabled', it means a sensor error is detected, and the backup sensor is in use. Unplug and reconnect the sensor cable. Check if the sensor is operated out of specified limits. If the problem persists, replace the sensor.
General| Communication Protocol | HART |
|---|---|
| Type | Temperature Transmitter |
| Output Signal | 4 to 20 mA, HART |
| Sensor | RTD, Thermocouple |
| Inputs | RTD, Thermocouple |
| Operating Temperature | -40 to 85 °C (-40 to 185 °F) |
| Protection Class | IP67 |
| Display | Optional LCD display |
To Next Page
