Simplex 4005 - Page 82

4-2
If there are multiple zones on a floor, you may wish to have the zones on each
floor assigned to a List. Then have this list turn ON the signal circuits.
Create a user List for each floor (Lists 31-08 through 31-25 are user defined List
Pseudo Points). The List should contain all Monitor zones on the floor. Don’t
forget to add a label for each List created.
Add the following equations:
Selective Signals by Floor - Equation 3
Equation Point Label Point Type
$1<),5('(7 VW)ORRU(DVW:LQJ=RQHV
(QGRI,QSXW
0$5&+3UL VW)ORRU(DVW:LQJ6LJ 6LJQDO
(QGRI2XWSXW
Selective Signals by Floor - Equation 4
Equation Point Label Point Type
$1<),5('(7 QG)ORRU(DVW:LQJ=RQHV
(QGRI,QSXW
0$5&+3UL QG)ORRU(DVW:LQJ6LJ 6LJQDO
(QGRI2XWSXW
Continued on next page
SMPL Language Applications, Continued
Selective Signals by Floor
(continued)
Technical Manuals Online! - http://www.tech-man.com