12
Updating from Firmware 2.x to 3.x
3 Updating from Firmware 2.x to 3.x
The following note is for the Solar-Log 200, 500 and 1000 models when updating to firmware version 3.x.
In order to update to 3.x, the Solar-Log™ must at least be running firmware version 2.x. The latest firmware
can be downloaded from our website:
http://www.solar-log.com/de/service-support/firmware.html.
Note!
After installing firmware 3.x, it is no longer possible to downgrade to the previous versi-
ons. It is not possible to install older firmware versions.
The following changes occur when upgrading to 3.x:
•
The data transfer function is no longer available.
•
The Smart Energy section has been completely revised. If the function External Switch (only So-
lar-Log 1000) is used, this part needs to be reconfigured after the update.
•
The settings and function of the power management have to be checked and, if need be, reconfi-
gured.
•
With the new modern web interface, old web browsers might sometimes cause problems with
the functionality. We recommend using the current version of Mozilla's Firefox, Google's Chrome,
Microsoft Edge or Microsoft's Internet Explorer.
As part of the update, the Solar-Log™ has a data reformatting process running in the background. This
process starts once the update is finished. This process could last several hours and the Solar-Log™ will
operate and react slower until the update finishes.
To Next Page
Loading...
Need help?
General
