Solar-Log 2000 - Fig.: Startup Screen of the Solar-Log Configuration Wizard; Fig.: Solar-Log Ethernet Settings Via the Solar-Log Configuration Wizard; Fig.: Example of a Successful Connection Test

69
Installation
Fig.: Startup screen of the Solar-Log™ conguration wizard
Click on the „Start“ button to run the configuration wizard. Once started, the Ethernet Settings menu ap-
pears (see image „Solar-Log™ Ethernet Settings via the Solar-Log™ configuration wizard“). In the network
settings can be entered in the IP address, subnet mask and gateway boxes. Instead of manually entering
the network settings, „Obtain IP address automatically (DHCP)“ function can be activated. A router with
DHCP enabled is required for this function.
Fig.: Solar-Log™ Ethernet Settings via the Solar-Log™ conguration wizard
Click on the „Connection Test“ button in the Internet connection section to check if the settings are cor-
rect.
Fig.: Example of a successful connection test