Solar-Log 2000 User Manual

286
Faults
21.2.5 Fault messages Export to External Server and Backup
These messages are shown in the Status box under Configuration | Network | Export and Configuration |
Network | Backup
.
Fault messages export (FTP)
Error code Message Possible cause or remedy
101 The server address could
not be resolved.
The access type was not congured. An
alternative DNS server is required. The wrong
server was entered. The network connection
was disconnected and could not be reestab-
lished.
102 Cannot open socket. Possible causes: Unknown. If this error conti
-
nues to occur, contact our technical support.
103 Cannot connect to the
socket.
Possible causes: The connection is blocked by
a rewall or a router. The wrong server was
entered. The server is ofine.
104 "No response from the
server."
There is a fault on the FTP server.
105 Wrong response from the
server.
The FTP server used is not supported or not
congured properly.
106 User / password incorrect. The user name or password for FTP access
was entered incorrectly.
107 Wrong directory. An incorrect directory was set for the trans
-
fer.
108 Unable to send the backup
le
The connection was closed. The speed was
too limited. Not enough disk space is availa
-
ble.
109 Too many users Too many users are logged in with this ac
-
count.
110 Log in error Unspecied log in error
111 Error with the remote le
names
This is an internal error. Contact support.
112 Error when setting the
representation type.
The FTP server used is not supported or not
congured properly.
Use another FTP server or check the congu
-
ration.
113 Error when setting the
passive mode.
The FTP server used is not supported or not
congured properly.
Use another FTP server or check the congu
-
ration.
The connection is being blocked by a rewall
=> make the necessary rewall congurations
to allow the connection. There is a problem
with the Internet connection => check if the-
re is a problem with the settings or with the
connection in general.
114 Socket could not be ope
-
ned.
This is an internal error => create a diagnosis
report from the Diagnosis | Report and send
it to support.
115 IP address could not be
changed.
This is an internal error => Contact support.

Solar-Log 2000 Specifications

General

Device Type	Data Logger
Max Inverters	100
Power Supply	24 V DC
Remote Monitoring	Yes
Ethernet interface	Yes
Communication Interfaces	RS485, Ethernet
Protocols	Modbus
Data Storage	Internal