283
Faults
21.2 Fault messages
21.2.1 Fault messages GPRS
These fault messages are shown in the LCD display and also in the Status box under Configuration | Net-
work | GPRS
.
Fault messages GPRS
Error code Message Possible cause/remedy
-101 Too many failed attempts After several failed attempts, the modem goes
into an error state. Reboot the device and obser-
ve which fault code is displayed rst.
-111 Wrong parameter No SIM pin, user name or password was ente
-
red. Enter these parameters even if they are not
needed. (e.g. 0000 for the pin or "user" for the
user name)
-135 Connection error There is no GSM network coverage or the signal
is too weak.
The antenna has not been properly attached.
10 No SIM card No SIM card has been inserted.
The SIM card has not been inserted correctly.
11 Pin required No pin or the wrong pin has been entered.
The pin lock has not been removed.
12 PUK required / card locked Possible causes:
• The wrong pin has been entered three times.
• The SIM card has not yet been unlocked.
16 Wrong password Enter the correct APN password.
111 Connection to the network
not allowed
The SIM card cannot nd an allowed network.
Try connecting to other providers.
268 Roaming required To connect to the network the roaming option is
required, but is currently deactivated.
To Next Page
Loading...
Need help?
General
