126
Configuration Menu
Note!
If the maximum number of notifications per day is defined too low, this can lead to im-
portant messages not being sent.
•
SAVE the settings.
In the Save menu, there are three different options:
•
SAVE
•
SAVE MULTIPLE
•
SAVE ALL
Save
When using this button, the settings for the device selected as the device are saved.
Save multiple
When using this button, a selection box appears from which other devices can be added by checking them.
Save all
When using this button, all of the settings are saved for all of the detected devices.
Using the same settings for several or all of the devices is a good idea when these devices also have the
same status and error codes.
Configuration example
Status codes 0 to 8, 12 to 15 and 31 to 45 should result in an e-mail notification being sent, and status codes
16-31 for a relay signal. The fault codes 0 to 30 should result in a text messages (SMS) notification being
sent.
This results in the following configuration:
Fig.: Con guration example for ltering status and fault codes
Note!
This filter can also be used for status notifications from other devices such as meters and
sensors as an option to deactivate notifications.
To Next Page
Loading...
Need help?
General
