Solar-Log 2000 User Manual

282
Faults
Restoring the factory settings
Press and hold the reset button with a non-conducting pointed object
•
The Solar-Log™ beeps and the following is displayed on the LCD:
•
After about 15 seconds, the Solar-Log™ beeps three times and the following is displayed:
•
Now release the button, the following is then displayed
•
The Solar-Log™ is reset to the factory settings
•
Reboot the Solar-Log™ with the new initial configuration
After the reset button is released, it is still possible to stop the reset to factory settings:
•
Press the reset button again within the first 5 seconds of the initialization phase.
21.1.4 Rebooting and Resetting via the web menu
Resetting the inverter configuration and deleting yield data:
See Chapter 16.5.5.

Solar-Log 2000 Specifications

General

Device Type	Data Logger
Max Inverters	100
Power Supply	24 V DC
Remote Monitoring	Yes
Ethernet interface	Yes
Communication Interfaces	RS485, Ethernet
Protocols	Modbus
Data Storage	Internal